Four settings are required when configuring a DHCP server: name The name of the DHCP scope (LAN). subnet The subnet range (192.168.1.0/24). option The DHCP option (Default Gateway, DNS, etc). option The value given to the DHCP option. Below is an example on how to add option 242 to an existing DHCP

Jul 17, 2018 DHCP Option 150 & DHCP Option 66 – Router Switch Blog Mar 06, 2013 Configure Cisco router as DHCP server - study-ccna.com A DHCP server is configured with a pool of available IP addresses and assigns one of them to the DHCP client. A Cisco router can be configured as a DHCP server. Here are the steps: Exclude IP addresses from being assigned by DHCP by using the ip dhcp excluded-address FIRST_IP LAST_IP; Create a new DHCP pool with the ip dhcp pool NAME command.

IANA: BOOTP and DHCP options. This option specifies a list of 32 bit IP addresses for routers on the client's subnet. The routers SHOULD be listed in order of preference.

IANA: BOOTP and DHCP options. This option specifies a list of 32 bit IP addresses for routers on the client's subnet. The routers SHOULD be listed in order of preference.

22 rows

Jun 15, 2020 Set-DhcpServerv4OptionValue The Set-DhcpServerv4OptionValue cmdlet sets an IPv4 option value at the server, scope, or reservation level. The definition for the option must already exist. This cmdlet fails if the option definition does not occur in the Dynamic Host Configuration Protocol (DHCP) server service. If you specify only the ReservedIP parameter, the option values are set at the reservation level. If you specify DHCP Option Numbers Diffserv code point for VoIP signalling and media streams. 135. HTTP Proxy For Phone Applications